Installation Instructions

Start off by dry-fitting your dash trim pieces on the vehicle’s dash. Note correct placement and use a pencil to outline the pieces for placement reference. Once you feel comfortable aligning the pieces on the dash, proceed to step 2.

Clean all the surfaces of the dash receiving dash trim with the isopropyl alcohol wipes included in your kit. If you have had Armor All or any other repellent applied to the dash, you will need to repeat the cleaning process 3 to 4 times. A good way to test if your dash is clean enough for kit installation is to stick a piece of masking tape on an area you have cleaned. If the tape sticks easily you are ready for installation, if the tape does not stick readily you will need to repeat the cleaning process.

To use the adhesive promoter stick, break the inner tube by pressing on the black dot on the promoter stick. Then very gently squeeze the promoter stick to start the flow to the brush, when you see the brush start to wet stop squeezing.
Apply the adhesive promoter (paint brush style) only to the areas of dash receiving trim. Once the adhesive promoter is open it starts to dry so apply the entire adhesive promoter to the dash before proceeding to step 4.

NOTE: the adhesive promoter should only be used on thin or bent trim parts or around air vents. In most situations, the 3M backing is sufficient by itself. 

3M Automotive Division 3M Center, Building 223-15-02 St. Paul MN 55144-1000, 1-800-362-7183